Network cable tester with PoE testing and length measurement up to 200 m
In your cart: 0
Delivery options to:
Choose countryThis network cable tester checks shielded STP and unshielded UTP cables. It maps wire connections, measures cable length and shows the distance to a break.
Cable and port checks
- Wiremap and tracing. Check for opens, shorts and crossed wires. The maximum range for wiremapping and tracing is 600 m.
- Length measurement. Measure cable lengths from 2.5 to 200 m with an accuracy of ±1.6 m.
- Port identification. Find the connected port on a switch or router by its flashing indicator. The tester also displays the connected switch’s network speed and protocol.
- PoE testing. View voltage, polarity, power supply mode and power sourcing equipment (PSE) type. The tester distinguishes IEEE 802.3af from IEEE 802.3at and also tests non-standard PoE switches within a 5–60 V DC range.
Signal modes and batteries
The tester supports analogue and digital modes. The transmitter and receiver have LED backlighting, and the receiver has built-in non-contact voltage detection (NCV). The tester requires 1 × 9 V 6R22 battery and 3 × AAA batteries. Batteries are not included.
| Cable types | CAT5e, CAT6a and CAT6 (STP and UTP) |
|---|---|
| Power supply | 1 × 6R22 battery (9 V) and 3 × AAA batteries, not included |
| Maximum wiremap and tracing range | 600 m |
| Cable length measurement range | 2.5–200 m |
| Cable length measurement accuracy | ±1.6 m |
| Maximum tracing signal voltage | 9 ± 1 V peak-to-peak |
| Tracing signal frequency | 130 kHz |
| Distance-to-break measurement | Yes |
| Signal modes | Analogue and digital |
| PoE test range | 5–60 V DC, standard and non-standard PoE switches |
| PoE voltage display | Yes |
| Detected PoE power sourcing equipment (PSE) types | IEEE 802.3af, IEEE 802.3at and non-standard PoE |
| Voltage protection | 48 V DC, 5 mA |
| LCD | 128 × 64 dot matrix with backlight |
| Wire connection checks | Wiremap, opens, shorts and crossed wires |
| Additional PoE readings | Power supply polarity and mode |
| Network port identification | Flashing switch or router port indicator |
| Switch information | Network speed and protocol |
| LED backlighting | Transmitter and receiver |
| Non-contact voltage detection (NCV) | Built into the receiver |
| EAN | 6971278906674 |
|---|
Are batteries included?
No. You need 1 × 9 V 6R22 battery and 3 × AAA batteries.
Can the tester measure cable lengths up to 600 m?
No. The 600 m maximum applies to wiremapping and tracing. The cable length measurement range is 2.5–200 m.
























Gudri pirkumi vienuviet