Fuel injector cleaner and tester ANCEL ANJ400, up to 8 bar
In your cart: 0
Delivery options to:
Choose countryThe ANCEL ANJ400 fuel injector cleaner and tester combines an ultrasonic bath with a test bench that runs at adjustable pressures up to 8 bar. It works with electromagnetic petrol injectors, including EFI, GDI, MPI and SFI types, and supports extended testing of low-resistance injectors such as 1 Ω units.
Cleaning and diagnostic functions
- Ultrasonic cleaning and backflushing. Ultrasound removes deposits from hard-to-reach surfaces, while backflushing helps dislodge contaminants from inside the injector and from its filter.
- Spray, flow and leak tests. Backlighting makes it easier to compare spray patterns and atomisation. The flow test measures delivery over 15 seconds, and the leak test checks whether the needle valve seals under pressure.
- Engine simulation. Simulate acceleration, deceleration or a combination of both, with simulated engine speeds from 100 to 9,900 rpm.
- Controls and display. Adjust pressure, pulse width and simulation settings and monitor them on the digital display. The unit automatically relieves fuel system pressure if power is cut unexpectedly.
| Manufacturer | ANCEL |
|---|---|
| Model | ANJ400 |
| Device type | Fuel injector cleaner and tester |
| Power supply | 220 V AC ±10%, 50/60 Hz or 110 V AC ±10%, 60 Hz (EU and US standards) |
| Input power | 230 W |
| Ultrasonic bath power and frequency | 100 W (38–39 kHz) |
| Resistance test accuracy | 0.1 Ω |
| Simulated engine speed range | 100–9 900 rpm (increment: 10 rpm) |
| Time range | 5–300 s (increment: 5 s) |
| Pulse width | 0–30 ms |
| Speed | 0–9 975 rpm |
| Fuel tank capacity | 2 400 ml |
| Operating pressure | 0–8 bar, adjustable |
| Display | Digital |
| Supported injectors | Electromagnetic injectors (EFI, GDI, etc.); piezoelectric injectors are not supported |
| Operating temperature | −10 °C to 40 °C |
| EAN | 6978281190175 |
|---|
Are GDI adapters and an injector pulse cable included?
Yes. The kit includes four GDI connectors of each type (12.5 diameter, 9.8 diameter and M18), a pulse cable for four injectors and four special cables.
What other accessories are included?
Two adjustment screws, a funnel, a fuel hose, an injector washer (11 × 4), a flat injector plate (14 × 4), a power cable, an upper injector rail, ten sealing rings (7.52 × 3.53), three R1/4 plugs, four connectors of each type (European standard Ø 13.6, standard Ø 10.6 and Mercedes-Benz mechanical M12×1.5), and a tool kit.
























Gudri pirkumi vienuviet