xTool SafetyPro AP2 V1.0 reusable pre-filter, black
Delivery options to:
Choose countryThe xTool SafetyPro AP2 V1.0 is a reusable pre-filter for the xTool SafetyPro AP2 air-cleaning system. It captures coarse particles during laser work before they reach subsequent filter stages, reducing the load on those stages.
The cyclone filter can be cleaned rather than immediately replaced. An ultra-dense carbon mesh combined with activated carbon absorbs gases and odours. Filtration performance is the same in manual and automatic modes.
The stated service life is up to 100–600 hours, depending on usage conditions. This black pre-filter is an accessory for the AP2 system.
| Intended use | For xTool laser engravers |
|---|---|
| Colour | Black |
| Type | Filter |
| Compatible system | xTool SafetyPro AP2 |
| Design | Reusable, cleanable cyclone pre-filter |
| Service life | Up to 100–600 hours, depending on usage conditions |
| Filter media | Ultra-dense carbon mesh and activated carbon for absorbing gases and odours |
| Filtration modes | Same filtration performance in manual and automatic modes |
| Compatible laser engravers | P2S, P2, S1, M1 Ultra, F1 Ultra, D1, D1 Pro, M1, F1 |
| EAN | 6928819530072 |
|---|
Can the pre-filter be cleaned?
Yes. It is a reusable cyclone pre-filter that can be cleaned rather than immediately replaced.
Which system is this pre-filter designed for?
It is designed for the xTool SafetyPro AP2 system. The listed compatible laser engravers are P2S, P2, S1, M1 Ultra, F1 Ultra, D1, D1 Pro, M1 and F1.
